46 specifications are subject to change without notice 5% of rated voltage product description miniature relays series m type mz 2 poles 10a monostable miniature size pcb mounting reinforced insulation 4 kv / 8 mm switching capacity 10 a dc coils 1.87 to 160 vdc ac coils 4.8 to 264 vac general purpose, industrial electronics types: standard, flux-free or sealed switching ac/dc load ordering key mz p a 200 47 10 type sealing version (a = standard) contact code coil reference number contact rating version a = 5.0 mm / ag cdo (standard) c = 5.0 mm / hard gold plated d = 5.0 mm / flash gilded s = 5.0 mm / ag sn 0 2 available only on request ag ni coil characteristics dc (20?) coil reference number winding resistance ? ? 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 10 10 10 10 10 10 10 15 15 15 15 15 15 15 15 15 15 15 rated voltage 200/002 020 vdc vdc operating range min. vdc max.vdc 200/002 020 11 30 55 110 170 280 450 720 860 1150 1750 2700 4300 6450 9900 12550 16200 23500 must release vdc 3.50 5.75 7.80 11.00 13.70 17.60 22.50 28.60 30.80 35.70 44.00 55;00 69.30 84.70 104.00 117.00 136.00 160.00 for general data , notes and special versions see page 48 2.5 4.1 5.6 8.0 10.0 12.5 16.0 20.5 22.5 26.0 32.5 40.5 51.5 64.5 83.0 95.0 109.0 125.0 1.87 3.13 4.28 6.14 7.56 9.49 12.30 15.50 17.10 19.70 24.90 30.90 39.60 49.20 63.60 73.00 83.30 96.00 1.98 3.30 4.52 6.49 7.99 9.98 13.0 16.3 18.0 20.7 26.2 32.6 41.8 52.0 67.2 77.0 87.9 101.0 2.6 4.3 5.9 8.5 10.5 13.0 17.0 21.5 23.5 27.0 34.5 42.5 54.5 68.0 87.5 101.0 115.0 132.0 mzp type selection sealing p : standard,suitable for sol dering and manual washing. f : flux-free, suitable for auto- matic soldering and partial immersion or spray washing. h : sealed with inert gas according to ip 67,suita- ble for automatic solde ring and/or partial immer- sion or spray washing. contact configuration 2 normally open contact (dpst -no {2-form a}) 2 normally closed contact (dpst -nc {2-form b}) 2 change over contact dpdt {2-form c}) contact rating 10 a 10 a 10 a contact code 200 020 002 046/47-mz 2p 10a eng 2-03-2001 11:48 pagina 46
specifications are subject to change without notice 47 47 specifications are subject to change without notice miniature relays series m type mz 2poles 10a monostable 2 reduction of expected life against load power factor cos ? dimensions pin view wiring diagrams load power factor diagrams 1 expected life at 250 vac (resistive loads and repetition rate 1000 cycles/h) 15% of rated voltage coil characteristics ac (20?) coil ref. no. winding resistance ? ? 90 91 92 93 94 95 96 97 rated voltage vac operating range min. vac max. vac must release vac 6 12 24 48 60 110 220 240 12 56 230 870 1500 5300 20000 25000 10 10 10 15 15 15 15 15 6.6 13.2 26.4 52.8 66.0 129.0 242.0 264.0 4.8 9.6 19.2 38.4 48.0 88.0 176.0 192.0 rated current (ma) 50hz 60hz 270.0 119.0 57.0 30.5 23.8 12.3 5.9 5.7 237.0 104.0 50.0 26.7 21.0 10.8 5.2 5.0 inductance h 0.059 0.267 1.123 4.170 6.450 22.400 100.200 107.800 contact characteristics rating material (standard version) 2) current (at 250vac) rated current max. switching current overload current (4sec on / 40sec off cycle) voltage rated voltage max.switching voltage (vde 0435) 10 a agcdo 10 a 12 a 14 a 250 vac 380 vac power max. switching power with resistive load in ac 3) max. switching power in dc minimum switching current 2) (typical value) life (see diagram 1) typical electrical life at max. resistive load 1000 cycles/h 500 cycles/h max.electrical repetition rate mech. life at 18000 cycles/h 2500 va see diagram 3 100ma at 24vdc 7.5 x 10 4 cycles 8 x 10 4 cycles 3600 cycles/h 50 x 10 6 cycles mzp...200/020/002 10a 200 020 002 200 020 002 mzp: h = 25,2 mm h? 4,3 - 5,3 mm mzf/mzh: h = 26.5 mm h? 2.8 - 3.8 mm h h v (volt) dc i (ampere) dc 3 max. switching power dc 2) 3) see pag. 48 046/47-mz 2p 10a eng 2-03-2001 11:49 pagina 47
|
